AUTHOR=Ezell N. Dianne Bull TITLE=Demonstrating autonomous controls on hardware test beds is a necessity for successful missions to Mars and beyond JOURNAL=Frontiers in Nuclear Engineering VOLUME=3 YEAR=2024 URL=https://www.frontiersin.org/journals/nuclear-engineering/articles/10.3389/fnuen.2024.1308045 DOI=10.3389/fnuen.2024.1308045 ISSN=2813-3412 ABSTRACT=

NASA and the Department of Defense are planning for a mission to Mars in the 2030s–2040s using nuclear thermal propulsion (NTP). NTP uses a nuclear reactor to heat flowing hydrogen and create thrust. A serious concern for crewed and uncrewed missions to Mars is the loss of reactor control. The reactor startup and initial rocket impulse are initiated in cislunar or near-earth orbital regions; therefore, radio communications between ground control and the NTP engine should occur in real time. However, radio communications can take more than 20 min, depending on planet positions, to reach Mars orbiters from ground control. To address this delay, local autonomous controls are implemented onboard the NTP engine to ensure acceptable operation. However, autonomous controls have not been demonstrated or implemented in research or power reactor contexts because of safety and reliability concerns. To enable autonomous controls development, demonstration, and validation, Oak Ridge National Laboratory has created a nonnuclear hardware-in-the-loop test bed. Sensors throughout the test bed relay system status and hardware response to the user control algorithm, including measurements of temperature, flow, pressure of a loop, control drum position, and drum speed. This paper discusses the development of this facility and user accessibility.