AUTHOR=Borges Carolina , Chícharo A. , Araújo A. , Silva J. , Santos R. M. TITLE=Designing of carbon fiber-reinforced polymer (CFRP) composites for a second-life in the aeronautic industry: strategies towards a more sustainable future JOURNAL=Frontiers in Materials VOLUME=10 YEAR=2023 URL=https://www.frontiersin.org/journals/materials/articles/10.3389/fmats.2023.1179270 DOI=10.3389/fmats.2023.1179270 ISSN=2296-8016 ABSTRACT=

Over the last few years, the use of carbon fiber-reinforced polymer composites (CFRP) in the aeronautic sector has significantly increased, given these materials’ outstanding properties. Consequently, the accumulation of composite residues is becoming an environmental hurdle. Therefore, in a world where sustainability and circularity remain on the lead, the replacement of thermosets by thermoplastics as polymeric matrices emerges as a promising technique, given the recyclability of these materials. Following this perspective, in this work, carbon fiber-reinforced polymer (CFRP) composite “residues” were incorporated into a poly(etheretherketone) (PEEK) matrix, as a strategy towards a more sustainable future, aiming at developing novel compounds for the aeronautic industry. The influence of two different fiber sizes (<600 and 600–1000 μm) on the neat PEEK properties was assessed through formulations developed using a co-rotating twin screw-extruder, under optimized processing conditions. Furthermore, the potential thermo-oxidative degradation, and the recycling feasibility of the neat PEEK and its compounds, were evaluated by submitting the materials to several thermo-mechanical cycles. The results showed that PEEK compounds were successfully prepared, and presented a good fiber distribution and absence of fiber agglomerates. A positive impact on the mechanical performance of PEEK was found by the incorporation of 3.3 wt.% of short carbon fibers (sCF) with larger sizes (600–1000 μm). The reprocessing of neat PEEK and its compounds for 15 consecutive cycles demonstrated their remarkable thermo-mechanical stability, without any sign of degradation or irreversible loss of properties. The fiber length and fiber length distribution of reprocessed compounds showed that major variations occurred after the first extrusion cycle, especially for larger sizes.