Skip to main content

EDITORIAL article

Front. Energy Res., 07 September 2022
Sec. Carbon Capture, Utilization and Storage
This article is part of the Research Topic Gas Hydrate and Hydrate Technology for Greenhouse Gas Mitigation View all 7 articles

Editorial: Gas hydrate and hydrate technology for greenhouse gas mitigation

Chun-Gang Xu,,
Chun-Gang Xu1,2,3*Wei ZhangWei Zhang4
  • 1Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, Guangzhou, Guangdong Province, China
  • 2CAS Key Laboratory of Gas Hydrate, Guangzhou, Guangdong Province, China
  • 3Guangdong Provincial Key Laboratory of New and Renewable Energy Research and Development, Guangzhou, Guangdong Province, China
  • 4Department of Thermal Science and Energy Engineering, School of Engineering, University of Science and Technology of China, Hefei, China

Hydrate-based carbon dioxide separation, capture, utilization and storage (CCUS) is a new carbon emission reduction technology. Compared with the traditional technologies, it has the advantages of high energy efficiency, large separation capacity, simple process and environment-friendly. Since the 1980s, the research on gas hydrate and hydrate-based technology has gradually attracted more and more attention and become one of the focus of research (Li et al., 2016). Presently, the research is mainly focused on solving the two aspects restricting the industrial application of hydrate technology, low gas consumption and slow hydrate formation rate, including thermodynamics, kinetics, micro mechanism of hydrate-based CO2 separation and capture and hydrate-based utilization and storage of CO2, such as CO2-CH4 replacement and exploitation of natural gas hydrate (NGH) (Xu et al., 2019).

Promoting gas hydrate formation and enhancing CO2 consumption during the hydrate formation under a certain temperature and pressure are the two key issues to transform hydrate-based technology from experiment to commercial application. This is also the top priority of current related research. The formation of gas hydrate is essentially the transformation of gas-liquid solid phases, involving heat and mass transfer and interfacial reaction. Increasing the gas-liquid contact area and promoting the mass and heat transfer in the process of hydrate formation are considered to be the two directions that researchers focus on to solve the commercial application of the hydrate technology. Therefore, researchers have proposed many physical/chemical methods such as mechanical stirring, bubbling, spraying, porous media and emulsification to promote gas-liquid contact during hydrate formation (Ma et al., 2016). However, despite years of research, the bottleneck restricting the commercial application of the hydrate technology has not been solved. Therefore, researchers return the research focus from dynamics to thermodynamics. It is recognized that the problem can be solved fundamentally only after the affecting mechanism of the gas hydrate formation is deeply acknowledged from the micro level. For example, by adding surfactant to water, reducing the solution interfacial tension and making more gas evenly dispersed in the liquid phase, the gas-liquid contact area is promoted from the mesoscopic and even microscopic. This way is proven to not only significantly improve the hydrate formation rate, but also improve the gas consumption. For another example, by using the chemical polarity and charging characteristics of gas and solution, an electric field is introduced into the hydrate formation process to make the gas-liquid miscible phase move each other under the action of the electric field, promote the gas-water contact from the micro level, and also effectively improve the formation rate of natural gas hydrate Zhao et al. However, this does not mean that the stronger the electric field, the better the effect of promoting the gas hydrate formation, because the higher Joule heat brought by the strong electric field and the ionization of metal ions with higher concentration are not conducive to the formation of gas hydrate. However, through this study, we can also determine that promoting sufficient and uniform gas-liquid contact between gas and water at the mesoscopic or micro level can more effectively solve the problems of slow hydrate formation rate and low gas consumption caused by difficult gas diffusion in the liquid phase during the hydrate formation. Therefore, we have got such a revelation: for future industrial applications, the increase of CO2 hydrate formation rate will also be mainly based on micro water vapor contact, supplemented by macro stirring or spray.

Hydrate-based CO2 capture technology can help to capture a large amount of CO2 from power plant flue gas or other centralized emission sources of CO2. However, for carbon emission reduction, CO2 capture is not the ultimate goal. The ultimate goal is to convert the captured CO2 into other types of carbon containing products for reuse, or realize CO2 permanent storage while using CO2. Hydrate-based CH4-CO2 replacement extracting CH4 from NGH is considered to be a technology with great potential and can achieve win-win results in carbon emission reduction and natural gas exploitation, and it is considered as a new way and technology to realize CCUS, because CO2 is also stored in the form of CO2 hydrate solid while realizing CH4 exploitation. Currently, the biggest problem of CH4 extraction from NGH by hydrate-based CH4-CO2 replacement method is the low production efficiency. The fundamental reason is the difficulty of CO2 gas diffusion in NGH reservoir (Wang et al., 2021). In fact, the basic condition for the replacement is that the concentration of CO2 in the peripheral gas phase of CH4 hydrate should exceed 20%, because the higher the CO2 concentration, the more opportunities to promote the mass transfer reaction between CO2 and CH4 in hydrate cage. Due to the porous structure in NGH, the size of pores, capillary effect in the NGH and input pressure are the main factors affecting CO2 diffusion. Without changing the physical structure of NGH and increasing the compression cost, the gas molecules smaller than CO2, such as H2 or N2, are introduced in the process of CH4-CO2 replacement to enhance the CH4-CO2 replacement efficiency. The research showed that due to the small size, H2 or N2 molecules can smoothly pass through the small pores of NGH and expand the pores in the NGH so that CO2 can pass through relatively smoothly, and finally result in the improvement of the replacement efficiency by around 16% (Ding et al.). In fact, this method has been verified as early as last century. American researchers used CO2/N2 mixture to extract CH4 from NGH in permafrost region in 2007, but this method has not been tested in seafloor (Oyama and Masutani, 2017). Because the small molecule H2 or N2 can not be stable in the stratum in the form of hydrate like CO2, and it may lead to some other problems such as gas leakage, unless it can completely recovered after the extraction. Therefore, future research will focus on improving the efficiency of replacement and storage, while more energy needs to be invested in the recovery and reuse of small molecular gases.

Moreover, the application of the hydrate-based technology in NGH exploitation is of great significance to alleviate the fossil energy crisis faced by human sustainable development. Different from oil and gas reservoirs, the NGH exists in the stratum in the form of solid and mixed with sediments to support the stability of the stratum. Therefore, there is a risk of geological collapse in the NGH exploitation. In addition, there are various forms of NGH in the stratum. The process of NGH exploitation is accompanied by the production of a large amount of water and sand, which increases the difficulty of exploitation. At present, only Japan and China have carried out experimental NGH exploitations in the Nankai Trough of Japan and Shenhu sea area of China, but they have not lasted for more than 2 months because of the problem of producing a large amount of water and sand (Yu et al., 2021). Therefore, relevant research still focuses on the simulation and experimental optimization of the exploitation technologies (Ruan et al., Yu et al., Yamamoto and Nagakubo).

Gas hydrate technology serving CCUS is receiving more and more attention. As a new technology different from the traditional one, the hydrate technology is the only technology that can synchronously realize CO2 separation, capture, utilization and storage, and has potential competitive advantages. However, the current research is still in the experimental stage, especially the research on the continuous process of CO2 separation, capture, utilization and storage has not yet appeared, which needs to be strengthened in the later research.

Author contributions

The Editorial is written by C-GX and WZ.

Acknowledgments

The authors greatly appreciate financial support from the Key Program of National Natural Science Foundation of China (51736009), the Natural Science Foundation of Guangdong Province, China (2019A1515011490), Guangdong Special Support Program-Local innovation and entrepreneurship team project (2019BT02L278), Special Project for Marine Economy Development of Guangdong Province (GDME-2018D002), Fundamental Research and Applied Fundamental Research Major Project of Guangdong Province (2019B030302004, 2020B0301 03003), Science and Technology Apparatus Development Program of the Chinese Academy of Sciences (YZ201619), Frontier Sciences Key Research Program of the Chinese Academy of Sciences (QYZDJSSW-JSC033).

Conflict of interest

The authors declare that the research was conducted in the absence of any commercial or financial relationships that could be construed as a potential conflict of interest.

Publisher’s note

All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article, or claim that may be made by its manufacturer, is not guaranteed or endorsed by the publisher.

References

Li, X. S., Xu, C. G., Zhang, Y., Ruan, X. K., Li, G., and Wang, Y. (2016). Investigation into gas production from natural gas hydrate: A review. Appl. Energy 172, 286–322. doi:10.1016/j.apenergy.2016.03.101

CrossRef Full Text | Google Scholar

Ma, Z. W., Zhang, P., Bao, H. S., and Deng, S. (2016). Review of fundamental properties of CO2 hydrates and CO2 capture and separation using hydration method. Renew. Sustain. Energy Rev. 53, 1273–1302. doi:10.1016/j.rser.2015.09.076

CrossRef Full Text | Google Scholar

Oyama, A., and Masutani, S. M. (2017). A review of the methane hydrate Program in Japan. Energies 10, 1447. doi:10.3390/en10101447

CrossRef Full Text | Google Scholar

Wang, Y. H., Lang, X. M., Fan, S. S., Wang, S. L., Yu, C., and Li, G. (2021). Review on enhanced technology of natural gas hydrate recovery by carbon dioxide replacement. Energy fuels. 35, 3659–3674. doi:10.1021/acs.energyfuels.0c04138

CrossRef Full Text | Google Scholar

Xu, C. G., Li, X. S., Yan, K. F., Ruan, X. K., Chen, Z. Y., and Xia, Z. M. (2019). Research progress in hydrate-based technologies and processes in China: A review. Chin. J. Chem. Eng. 27, 1998–2013. doi:10.1016/j.cjche.2018.12.002

CrossRef Full Text | Google Scholar

Yu, Y. S., Zhang, X. W., Liu, J. W., Lee, Y. H., and Li, X. S. (2021). Natural gas hydrate resources and hydrate technologies: A review and analysis of the associated energy and global warming challenges. Energy Environ. Sci. 14, 5611–5668. doi:10.1039/d1ee02093e

CrossRef Full Text | Google Scholar

Keywords: CCUS, Hydrate, CO2 capture, NGH, CH4-CO2 conversions

Citation: Xu C-G and Zhang W (2022) Editorial: Gas hydrate and hydrate technology for greenhouse gas mitigation. Front. Energy Res. 10:849490. doi: 10.3389/fenrg.2022.849490

Received: 06 January 2022; Accepted: 08 August 2022;
Published: 07 September 2022.

Edited and reviewed by:

Hailong Li, Central South University, China

Copyright © 2022 Xu and Zhang. This is an open-access article distributed under the terms of the Creative Commons Attribution License (CC BY). The use, distribution or reproduction in other forums is permitted, provided the original author(s) and the copyright owner(s) are credited and that the original publication in this journal is cited, in accordance with accepted academic practice. No use, distribution or reproduction is permitted which does not comply with these terms.

*Correspondence: Chun-Gang Xu, eHVjZ0Btcy5naWVjLmFjLmNu

Disclaimer: All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.