Marif Daula Siddique
Saad Mekhilef
Natarajan Prabaharan
Mahrous Ahmed4
Hazlie Mokhlis- 1Department of Mechanical Engineering, Center for Energy Harvesting Materials and Systems, Virginia Tech, Blacksburg, VA, United States
- 2School of Science, Computing and Engineering Technologies, Swinburne University of Technology, Hawthorn, VIC, Australia
- 3Department of Electrical and Electronics Engineering, SASTRA Deemed University, Thanjavur, India
- 4Faculty of Energy Engineering, Aswan University, Aswan, Egypt
- 5Department of Electrical Engineering, Universiti Malaya, Kuala Lumpur, Malaysia
Editorial on the Research Topic
Emerging boost converter topologies for renewable energy applications
Introduction
The role of the power electronic converter is crucial for the effective utilization of renewable energy resources. Power electronic converters are used as an interface between renewable energy sources and their utilization, which can be in industrial loads, utility grids, and domestic loads. The main converters used with renewable energy resources are DC/DC converters and DC/AC converters. As the voltage magnitude of most renewable energy resources is low, a boost stage is required between the source and the load. Therefore, a new category of high gain DC/DC converters and DC/AC converters are required with higher reliability and efficiency.
A multilevel inverter (MLI) topology is a matured power converter, and it is most suitable for medium and high voltage applications with renewable energy. Most of the multilevel inverters use isolated DC sources, which limit their applications. By replacing the DC source with capacitors, a significant reduction in the cost and size of the converters can be achieved. This attractive feature has led researchers to develop boost multilevel inverters with fewer switches. The boosting feature enables the use of MLI in photovoltaic (PV)-based applications. Further, the switched capacitor MLI (SCMLI) topologies need further improvement in terms of developing new additional circuits, and control and modulation techniques to balance floating capacitor voltages.
Published articles
This Research Topic is intended to give an insight into the latest studies concerning the design and development of switched-capacitor topologies and other boost inverter topologies and related issues. In this issue, four articles have been accepted. The article by Amrr et al. investigates the use of a new sliding mode control for the output voltage regulation of a boost converter under parametric uncertainties of load resistance and input voltage. The authors also performed stability analysis of the closed-loop system, which guarantees the finite-time convergence of output voltage to the desired value while ensuring robustness against uncertainties. The simulation and hardware results are discussed in the article. The article by Kakar et al. proposes a new seven-level ANPC-type multilevel inverter topology with boost ability. The proposed inverter’s maximum efficiency was 97.5% at 1.2 kW-rated power, and the simulation and hardware results have been provided to validate the proposed topology. A sliding mode technique for the speed control of a wind turbine-driven double-fed induction generator is proposed by Ali et al. In this article, the authors present a detailed modeling of DFIG for finite-time stability. A comparison has been provided between the proposed controller and other conventional controllers. In the fourth article, authored by Karn et al., a load-shedding technique has been proposed for the multimachine system. A MATLAB/Simulink environment verifies and tests the method’s practicality on an IEEE-10-machine-39-bus system.
Perspectives
The articles published in this Research Topic show the progress in the field of power converters and their use in various applications. Most of the concepts proposed in the articles have been validated experimentally. However, there is a lot of scope for further improvement in the field of power converters and their uses.
Author contributions
All authors listed have made a substantial, direct, and intellectual contribution to the work and approved it for publication.
Conflict of interest
The authors declare that the research was conducted in the absence of any commercial or financial relationships that could be construed as a potential conflict of interest.
Publisher’s note
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article, or claim that may be made by its manufacturer, is not guaranteed or endorsed by the publisher.
Keywords: multlevel inverter, power electoronics, power electonic converter, dc/ac conversion, boost converter
Citation: Siddique MD, Mekhilef S, Prabaharan N, Ahmed M and Mokhlis H (2022) Editorial: Emerging boost converter topologies for renewable energy applications. Front. Energy Res. 10:1084922. doi: 10.3389/fenrg.2022.1084922
Received: 31 October 2022; Accepted: 11 November 2022;
Published: 28 November 2022.
Edited and reviewed by:
ZhaoYang Dong, Nanyang Technological University, SingaporeCopyright © 2022 Siddique, Mekhilef, Prabaharan, Ahmed and Mokhlis. This is an open-access article distributed under the terms of the Creative Commons Attribution License (CC BY). The use, distribution or reproduction in other forums is permitted, provided the original author(s) and the copyright owner(s) are credited and that the original publication in this journal is cited, in accordance with accepted academic practice. No use, distribution or reproduction is permitted which does not comply with these terms.
*Correspondence: Marif Daula Siddique, marifdaula1@gmail.com