AUTHOR=Fang Chao , Li Shiyuan , Zhao Qing , Zhang Hui , Chen Zhaowei , Huang Hao , Lin Zili , Fan Jinchao , Liu Enbo TITLE=Influence of mechanical characteristics of deep composite salt-gypsum layers on safe drilling of directional wells: a case study of Palaeogene in the Kuqa Piedmont structure, Tarim Basin, China JOURNAL=Frontiers in Earth Science VOLUME=11 YEAR=2023 URL=https://www.frontiersin.org/journals/earth-science/articles/10.3389/feart.2023.1130805 DOI=10.3389/feart.2023.1130805 ISSN=2296-6463 ABSTRACT=

The directional wells can effectively improve the development efficiency of deep and ultra-deep pre-salt oil and gas reservoirs in the Kuqa Mountains of Tarim basin. Under the condition of deep temperature and pressure, the mechanical properties of the composite salt-gypsum layers are complex. During the directional drilling process, that the salt rock is easy to creep causes the drill stick. Under the condition of controlling the well inclination, it is difficult to choose the appropriate drilling fluid density to resist creep and thus maintain the stability of the wellbore. On the basis of rock mechanics experiments, this study established a two-dimensional finite element model considering the combination of composite salt-gypsum layers and inclined well with the effect of in-situ stress, analyzed the influence of temperature, differential stress and well deviation on the salt rock creep. The density of drilling fluid for preventing creep sticking is calculated, and a safe drilling fluid density chart for preventing creep shrinkage of composite salt-gypsum layers is compiled. The results show that when the differential stress is less than 10 MPa, the creep rate of the Tarim composite salt-gypsum layers are at least 10 times higher than that of the Gulf of Mexico salt layers; the creep rate increases with the increase of the differential stress and temperature, and the creep rate is an incremental curve; taking the highly deviated well in the Bozi area as an example, where the shrinkage ratio caused by sticking is set to be 5%, the drilling fluid density chart for creep resistance at 45° and 60° inclination is built, which is consistent with the actual drilling in the field. The results can provide design basis for the selection of anti-creep drilling fluid density in the directional wells in the Kuqa Piedmont composite salt-gypsum layers.