This article is a correction to:
Laser Metal Deposition of Ultra-Fine Duplex AlCrFe2Ni2-Based High-Entropy Alloy
Veronica Rocio Molina
Andreas Weisheit
Sergej Gein
Ulrike Hecht
Dimitrios Vogiatzief- 1Fraunhofer Institute for Laser Technology ILT, Aachen, Germany
- 2Access e.V., Aachen, Germany
- 3Oerlikon AM, Feldkirchen, Germany
A Corrigendum on
Laser Metal Deposition of Ultra-fine Duplex AlCrFe2Ni2-based High-Entropy Alloy
by Molina, V. R., Weisheit, A., Gein, S., Hecht, U., and Vogiatzief, D. (2020). Front. Mater. 7:275. doi: 10.3389/fmats.2020.00275
In the original article, there was a mistake in Figure 10 as published. The legend colors did not match to the depicted lines, which confuses the reader. The corrected Figure 10 appears below.
FIGURE 10
FIGURE 10. Bending test trendlines–stress (MPa) vs. strain (%) for laser material deposition fabricated B samples in as-built and heat-treated condition in a vertical build orientation (Vertical_As-Built, Vertical_HT), heat treated in a horizontal build orientation (Horizontal_HT), and a reference heat-treated DIN St.1.4517 cast sample material (Cast_DIN-St1.4517_HT).
The authors apologize for this error and state that this does not change the scientific conclusions of the article in any way. The original article has been updated.
Keywords: laser meterial deposition, high-entropy alloy, AlCrFeNi alloy, duplex microstructure, additive manufacturing
Citation: Molina VR, Weisheit A, Gein S, Hecht U and Vogiatzief D (2020) Corrigendum: Laser Metal Deposition of Ultra-Fine Duplex AlCrFe2Ni2-Based High-Entropy Alloy. Front. Mater. 7:594883. doi: 10.3389/fmats.2020.594883
Received: 14 August 2020; Accepted: 31 August 2020;
Published: 18 September 2020.
Approved by:
Frontiers Editorial Office, Frontiers Media SA, SwitzerlandCopyright © 2020 Molina, Weisheit, Gein, Hecht and Vogiatzief. This is an open-access article distributed under the terms of the Creative Commons Attribution License (CC BY). The use, distribution or reproduction in other forums is permitted, provided the original author(s) and the copyright owner(s) are credited and that the original publication in this journal is cited, in accordance with accepted academic practice. No use, distribution or reproduction is permitted which does not comply with these terms.
*Correspondence: Veronica Rocio Molina, dmVyb25pY2EubW9saW5hQGlsdC5mcmF1bmhvZmVyLmRl