Chao Xie
Zupeng Chen
Chang Geun Yoo
Xiaojun Shen
Qidong Hou
Leslie Boudesocque-Delaye- 1National and Local Joint Engineering Research Center on Biomass Resource Utilization, College of Environmental Science and Engineering, Nankai University, Tianjin, China
- 2Jiangsu Co-Innovation Center of Efficient Processing and Utilization of Forest Resources, International Innovation Center for Forest Chemicals and Materials, College of Chemical Engineering, Nanjing Forestry University, Nanjing, China
- 3Department of Chemical Engineering, College of Environmental Science and Forestry, State University of New York, Syracuse, NY, United States
- 4Beijing Key Laboratory of Lignocellulosic Chemistry, Beijing Forestry University, Beijing, China
- 5EA 7502 SIMBA, Université de Tours, Faculté de Pharmacie, Tours, France
Editorial on the Research Topic
The application of green chemistry in biomass valorization: green route, green catalyst and green solvent
Introduction
The rapid growth of the population has resulted in the drastic exhaustion of non-renewable fossil resources and a dramatic increase in atmospheric CO2 concentration, which in turn led to severe energy and environmental crises. Therefore, it is highly urgent to develop renewable energy to meet the sustainable development of society. Biomass valorization presents a great approach for the substitute of fossil sources. However, the conversion of biomass into desirable products requires a series of complex deconstruction, catalytic conversion, separation, and purification processes (Hou et al., 2021), the harsh conditions may cause a series of environmental problems. Green Chemistry is defined as the “design of chemical products and processes to reduce or eliminate the use and generation of hazardous substances.” (Anastas, 2007), the application of green chemistry principles in biomass valorization is important and has become a steadily increasing field of research.
The Research Topic “The Application of Green Chemistry in Biomass Valorization: Green Route, Green Catalyst and Green Solvent” covers the green approach in biomass valorization, including green routes, green catalysts, and green solvents. Here we sincerely appreciate the 28 authors for their nice work on this Research Topic. Following are the highlights drawn from their contributions to this Research Topic.
Oxidation of glucose to gluconic acid by photocatalytic strategy
Solar energy is considered a promising energy source due to its inexhaustibility, universality, high capacity, and environmental friendliness (Gong et al., 2019). The innovative combination of photocatalysis with biomass transformation represents a promising approach to achieving sustainability in chemical processes (Granone et al., 2018). The contribution by Zhang et al. designed a photocatalysis by regulating the composition and structure, they investigated the insertion of different central metal ions, Fe, Co, Mn, and Zn, into porphyrazine loading with SnO2 for access to the more efficient transformation of glucose into value-added organic acids in aqueous solution at mild reaction conditions. 41.2% conversion of glucose can be reached with 85.9% selectivity of organic acids (including glucaric acid, gluconic acid, and formic acid) after 3 h when using SnO2/CoPz as a photocatalyst. They found that the central metal in metaloporphyrazine on the surface of SnO2 has a significant effect on the separation of photogenerated charges, changing the adsorption and desorption of glucose and products on the catalyst surface.
Transfer biomass-derived HMF into high-value-added chemicals by electrocatalytic strategy
Electricity is considered potential green energy as it can be generated from wind, solar, geothermal, and closed-loop biomass facilities (Menz, 2005). Besides, the electrocatalytic conversion of biomass-derived platform chemicals provides an approach to storing large-scale renewable energy in chemical bonds (Du et al., 2018). Liu et al. designed a nickel phytic acid hybrid (Ni-PA) by using natural phytic acid as a building block for the electrocatalytic oxidation of HMF to 2, 5-furan dicarboxylic acid at 1.6 V vs. RHE, the yield of 2, 5-furan dicarboxylic acid and Faraday efficiency could reach 99.1% and 90%, respectively. Detailed investigation revealed that the good catalytic performance can be attributed to the coordination of nickel ion and phosphate groups of the phytic acid molecule, the higher electrochemical surface area, and lower charge transfer resistance than other tested catalysts.
Co-production of biohydrogen (H2) and biomethane (CH4) from biomass sources by biotechnology
The anaerobic fermentation process also presents a green and effective way to generate high value-added products from biomasses sources by biotechnology. Nawaz et al. assessed the co-production of biohydrogen (H2) and biomethane (CH4) by a two-stage anaerobic fermentation process utilizing Atriplexcrassifolia as feedstock. In the first stage, 5 g Atriplexcrassifolia and 10 mL pretreated sewage sludge were processed at 37°C and pH 5.5 after 48 h of incubation, the maximum cumulative hydrogen production, hydrogen production, hydrogen production rate was 66 ± 0.02 mL, 13.2 ± 0.03 mL/g, and 1.37 ± 0.05 mL/h, respectively. In the second stage, 40 mL of hydrogenic slurry with 80 mL inoculum was incubated at 45°C and pH 8 for 18 days, the maximum cumulative methane production, methane yield, and methane production rate can be reached at 343 ± 0.12 mL, 8.5 ± 0.07 mL/mL, and 0.8 ± 0.05 mL/h, respectively.
The replacement of fossil sources with biomass derivates to produce high-value products
Polymer materials derived from fossil resources are widely used in our daily life. However, these polymers derived from petroleum resources are generally non-biodegradable and most of them are buried or burned after the end of their useful lives, leading to serious environmental problems. Thus, the development of biodegradable biomaterials to substitute fossil-based polymers has attracted much attention. Wang et al. reported the synthesis of glycidyl 4-pentenoate from lignocellulose-based 4-pentenoic acid, which was further copolymerized with CO2 using a binary catalyst SalenCoCl/PPNCl to produce bio-based polycarbonates with vinyl side chains and molecular weights up to 17.1 kg/mol. By introducing petrochemical-derived propylene oxide as the third monomer, the GPA/PO/CO2 terpolymer can be produced. The glass transition temperature can be adjusted from 2°C to 19°C by controlling the molar feeding ratio of GPA to PO from 7:3 to 3:7.
Author contributions
CX: Conceptualization, Writing–original draft, Writing–review and editing. ZC: Writing–review and editing. CY: Writing–review and editing. XS: Writing–review and editing. QH: Writing–review and editing. LB-D: Writing–review and editing.
Acknowledgments
We thank all authors, reviewers, topic editors, and editorial staff at Frontiers who contributed to this Research Topic.
Conflict of interest
The authors declare that the research was conducted in the absence of any commercial or financial relationships that could be construed as a potential conflict of interest.
The author(s) declared that they were an editorial board member of Frontiers, at the time of submission. This had no impact on the peer review process and the final decision.
Publisher’s note
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article, or claim that may be made by its manufacturer, is not guaranteed or endorsed by the publisher.
References
Anastas, P. T. (2007). Introduction: green chemistry. Chem. Rev. 107, 2167–2168. doi:10.1021/cr0783784
Du, L., Shao, Y., Sun, J., Yin, G., Du, C., and Wang, Y. (2018). Electrocatalytic valorisation of biomass derived chemicals. Catal. Sci. Technol. 8, 3216–3232. doi:10.1039/c8cy00533h
Gong, J., Li, C., and Wasielewski, M. R. (2019). Advances in solar energy conversion. Chem. Soc. Rev. 48, 1862–1864. doi:10.1039/c9cs90020a
Granone, L. I., Sieland, F., Zheng, N., Dillert, R., and Bahnemann, D. W. (2018). Photocatalytic conversion of biomass into valuable products: a meaningful approach? Green Chem. 20, 1169–1192. doi:10.1039/c7gc03522e
Hou, Q., Qi, X., Zhen, M., Qian, H., Nie, Y., Bai, C., et al. (2021). Biorefinery roadmap based on catalytic production and upgrading 5-hydroxymethylfurfural. Green Chem. 23, 119–231. doi:10.1039/d0gc02770g
Keywords: biomass transformation, biomass utilization, biomass materials, green chemistry, green solvent
Citation: Xie C, Chen Z, Yoo CG, Shen X, Hou Q and Boudesocque-Delaye L (2023) Editorial: The application of green chemistry in biomass valorization: green route, green catalyst and green solvent. Front. Chem. 11:1277256. doi: 10.3389/fchem.2023.1277256
Received: 14 August 2023; Accepted: 15 August 2023;
Published: 22 August 2023.
Edited and reviewed by:
James Clark, University of York, United KingdomCopyright © 2023 Xie, Chen, Yoo, Shen, Hou and Boudesocque-Delaye. This is an open-access article distributed under the terms of the Creative Commons Attribution License (CC BY). The use, distribution or reproduction in other forums is permitted, provided the original author(s) and the copyright owner(s) are credited and that the original publication in this journal is cited, in accordance with accepted academic practice. No use, distribution or reproduction is permitted which does not comply with these terms.
*Correspondence: Chao Xie, xiechao@nankai.edu.cn